Chargeplanner Help Center
News
Chargeplanner Help Center
News
Getting started
User guides
Power user guides
Introduction
Optimize
How to use the Optimize moduleCalculate in batch new locations for optimal network expansionCalculate in batch your optimal characteristic to optimize your networkCreate a projectSelect a PeriodChoose a Data setPrepare your list of location in the templateUpload the templateCalculate the projectResults interpretation guide after calculation Reviewing and working with your project resultsExport resultsHow to create a simulation from tested locationsHow to add, remove, or update locations in your projectDefinitions of ready-to-use inspiration setsDetailed list of information in Optimize table
Data management & Settings
FAQs
Troubleshooting

Select a Period

After choosing the type of project you want to create, you have to decide which period you want to base your project on. There are two types of references to choose from:

  • Baseline: period on which your baseline network is based
  • Simulation: period where you made changes to the network. You can find there your simulations previously saved using the Location Planning module (you can learn how to save a simualtion in this article).

Once you have made your choice, you can click on the 'Next' button to confirm your choice and move on to the next step.

 

You are ready to go to the next step: Select a data set.

 

Was this article helpful?

English
Powered by Product Fruits